Rockwell 70-602, Техническое руководство

Страница: 14 / 48

DRILLING HOLES TO DEPTH
When drilling one or two holes to a predetermined
depth, the calibrations on the face of the depth stop
rod (F) Fig. 7 can be used.
When drilling a number of holes to a predetermined
depth, or if a more exact setting is required, proceed
as follows:
1. Raise the locking sleeve (A) Fig. 7, and turn the
micro-nut (G) to the desired position on the stop rod
( F ) .
2, Lower the locking sleeve (A) so it will engage
micro-nut (G) Fig. 7. Lock sleeve (A) in place with
thumb screw if drill press is mounted in other than
vertical position. When the drill press is mounted with
t h e c h u c k p o i n t i n g “ u p ” , the locking sleeve (A) and
micro-nut (G) Fig. 7, should be reversed on the stop
rod (F).
3. When locking sleeve (A) is in place on the micro-
nut (G) Fig. 7, the micro-nut cannot be turned. When
a change in depth is required, the locking sleeve (A)
must be raised, and while it is raised, turn the micro-
nut (G) the necessary calibration marks. Each mark
represents .002”. Then lower the locking sleeve (A).
4. The use of the micro-set stop nut will maintain the
same hole depth, no matter how many holes are to be
drilled. However, we recommend that the hole depth
be checked whenever a drill has to be sharpened or
changed.
SAFETY SUGGESTIONS FOR
DRILL PRESSES
1 . I F Y O U A R E N O T t h o r o u g h l y f a m i l i a r w i t h t h e
operation of Drill Presses, obtain advice from your
Supervisor or Instructor.
2. M A K E S U R E w i r i n g c o d e s a n d r e c o m m e n d e d
electrical connections are followed and that machine
is properly grounded.
3. REMOVE tie, rings, watch and other jewelry, and
roll up sleeves.
4. ALWAYS wear safety glasses or a face shield.
5. GUARDS should be in place and used at all times.
6 . C H A N G E V A R I A B L E S P E E D S w i t h t h e m o t o r
r u n n i n g .
7. MAKE all adjustments with the power off.
8. B E S U R E d r i l l b i t o r c u t t i n g t o o l i s s e c u r e l y
locked in the chuck.
9. BE SURE chuck key is removed from the chuck
before turning on power.
10. ADJUST the table or depth stop to avoid drilling
into the table.
11. H O L D t h e m a t e r i a l s e c u r e l y w i t h a v i s e o r
clamps.
12. DISCONNECT drill from the power source when
making repairs.
13. SHUT OFF the power, remove the drill bit or cutting
tool, and clean the table before leaving the machine.
8