Rockwell Automation Allen-Bradley LDAT-S03 Series, Руководство пользователя

Страница: 53 / 76

Rockwell Automation Publication LDAT-UM001A-EN-P - April 2016 53
Maintenance Chapter 5
Strip Cover Cleaning Clean the strip cover using a lint free cloth lightly saturated with isopropyl
alcohol.
Storage
Store your linear thruster for a minimal amount of time in a clean and dry
location within the environmental specifications see Kinetix Linear Motion
Specifications, publication
GMC-TD00
2
Observe these conditions when storing the linear thruster:
• Be sure the equipment is in good working order before storing. Perform
repairs, maintenance, and inspections before storing equipment.
• Store the equipment in a horizontal position and prevent damage to the
connectors and electronics.
• After six months of storage, cycle the linear thruster two complete
strokes to redistribute the internal lubricants.
• After storage for a period longer than two years without use, lubricant
replacement is recommended.
Install Replacement Parts Be sure to have all replacement parts and tools available before starting this
procedure. Read and understand procedures before attempting repair any part
of the linear thruster.
You need a set of hex wrenches to preform most tasks and a T10 Torx driver to
replace the encoder.
Replace the Bearing
1.
Disassemble the linear thruster by following procedure on page 53 .
2.
Remove the bearing by following procedure on page 58 .
3.
Install the bearing by following procedure on page 58
4.
Assemble the linear thruster by following procedure on page 56
IMPORTANT Replace the strip cover if it cannot be cleaned, is uneven, or scored.
A buildup of foreign material on the strip cover degrades the performance of
the linear thruster. The combination of a buildup and the rapid movement of
the slider causes friction that can score and burnish the strip cover.
Typical buildup on the strip covers are dust, grease, and contaminants found
in an uncontrolled operating environment.