15
Assembly - Damper Shaft and Eyelet
RL, RT, Select R:
Thread the damper shaft assembly
into the eyelet by hand until it stops.
RL, RT, Select R:
Clamp the damper shaft into a vise
with RockShox Vise Blocks (3-hole) (10 mm slot), just below the eyelet.
Secure the crowfoot wrench on the (A) eyelet mount flats (standard,
trunnion, or bearing). Tighten the eyelet to the specified torque.
Note:
When the eyelet and damper shaft are tightened to the specified
torque, the rebound rod assembly or rebound poker assembly is sized
to the correct postion inside the damper shaft. This step is critical for
proper damper function.
Remove the damper from the vise.
Eyelet
Crowfoot
Standard
13 mm
Bearing
29 mm
Trunnion
54 mm
RT, RL, Select R:
Install the (A) Bottomless Token(s)
(if previously installed), the (B) travel reducer washer and the travel
reducer (if previously installed), and the (C) washer and bottom out
bumper.
RT, RL, Select R:
Clamp the damper shaft into a vise
with RockShox Vise Blocks (3-hole) (10 mm slot), just below the eyelet.
Install the seal head/air piston.
Refer to the
2023 Deluxe (C1) Service Manual
for detailed installation
procedures and specifications.
3
RL, RT, Select R
RL, RT, Select R
4
RockShox Vise Blocks (3-hole) - 10 mm slot
Crowfoot -
See Table
7.9 N•m (70 in-lb)
A
RL, RT, Select R
RL, RT, Select R
A
B
C
C
B
5
RockShox Vise Blocks (3-hole) - 10 mm slot
RockShox Vise Blocks (3-hole) - 10 mm slot
