Rocks OK-03.4130, Руководство пользователя

Страница: 25 / 106

25
EN
- Use the virtual wire to isolate areas inside the working
area by creating islands around obstacles that can not
withstand a collision, for example, flower beds and
fountains. Run the wire out to the area, route it around
the area to be isolated and then back along the same
route. If pegs are used, the wire should be laid under
the same peg on the return route. When the virtual wire
to and from the island with a maximum distance of 1cm,
the mower can drive over the wire.
- If protected obstacles are grouped closely together
isolate them individually. Continuous virtual island
if obstacles are close to edge, leave them out of the
mowing area.
- Care must be taken not to create a corner sharper
shorter than 90 degrees when setting up virtual wire.
A corner sharper less than 90 degrees can cause the
mower to lose track of virtual wire. We can make
greater than 90 degrees corner like follow picture
shows.
- The distance between charging station and virtual
loop should be 2 meters at least.
Virtual wire
connecting
- Joining the
virtual wire.
If the virtual
wire is not long
enough and needs
to be spliced:
Use supplied
wire connector.
It is waterproof
and gives a
reliable electrical
connection.
To splice: Insert both cable ends in the connector. Now
press down the button on top of the connector fully.
Use a pair of pliers or the like, as the button on the
connector is difficult to press down by hand.