Robur GAHP-W, Инструкция по установке, эксплуатации и обслуживанию, Страница: 52 / 68

GAHP-W – Installation, start-up, use and maintenance manual
50
Edition: 2014-08
- outlet cold water temperature, inlet cold water temperature, cold water ∆ T
- outlet hot water temperature, inlet hot water temperature, hot water ∆ T
Example:
INLET COLD WATER TEMPERATURE
OUTLET COLD WATER TEMPERATURE
COLD WATER ∆ T
OUTLET HOT WATER TEMPERATURE
INLET HOT WATER TEMPERATURE
HOT WATER
∆ T
Table 22 - Operating information example
If any warning or error occurs, the display shows, sequentially, the codes corresponding to
the problem detected. A description of these codes is provided in chapter 4.9 -
OPERATING CODES - TROUBLESHOOTING (firmware release 3.027) on page 57.
The encoder is used for surfing through the menus for setting the parameters.
To use the encoder:
1.
Remove the front panel of the unit.
2. Remove the plug on the cover of the electric panel.
3. Rotate and press the encoder through the hole on the cover of the electric panel
using the small pipe supplied with the unit.
•
Press the encoder to access the S61 menu list .
•
Rotate the encoder to scroll the menu. Choose the menu you want to access.
Press “E” if you want to exit .
•
Press the encoder to enter the chosen menu .
•
Rotate the encoder to scroll parameters. Choose the parameter you want to edit.
Press “E” if you want to exit.
•
Press the encoder to enter the chosen parameter .
•
Rotate the encoder to edit the value of the parameter (if it is not a “read only”
parameter) .
•
Press the encoder to confirm the number and exit to the previous menu.