RoboVent CLARION CFX Series, Руководство пользователя

Страница: 12 / 38

12 ROBOVENT • CLARION SERIES OWNER’S MANUAL
SECTION 500
Operation
Clarion Oil Mist Collector Start-Up
Once the Collector is properly mounted, the proper flex duct
installed, the drain hoses and sump primed and electrical power is
connected you are ready for Start Up.
1. Check Blower Rotation:
Check blower rotation of the unit
by jogging the motor. Proper blower rotation can be observed
by either removing the blower access panel or by looking down
through the vents in the top of the motor. Blower rotation
should be
CLOCKWISE when viewed from above the motor. The
blower will still draw air if run backward but it will only be a
fraction of what it should be (see Figure 15).
2. Check filters. Make sure all the filters are sealed around the
edges and that there is no air-flow between the track and the
filter.
3. Check the drainage system.
Make sure each looped drain
line is full with fluid. If coolant is sucked back up into the
Collector you may need to increase the size of the loop in the
line. Periodically check that there is coolant in the drain loops
at all times (when using the loop installation method). This is
extremely important in the functioning of the Clarion unit.
4. Record differential pressure. Over the first several weeks it will be important to monitor the differential
pressure from the dirty air to clean air side. If static pressure increases rapidly there may be an issue with the
application which may require a different filter combination. In this case call RoboVent Technical Support at
1-(888)-762-6836, or email: customer.service@robovent.com
Motor
Blower
Wheel
Venturi
FIGURE 15