RoboVent CLARION CFX Series, Руководство пользователя

Страница: 10 / 38

10 ROBOVENT • CLARION SERIES OWNER’S MANUAL
SECTION 400
Installation
The Clarion Oil Mist Series
The RoboVent Clarion Oil Mist Series Collectors are universally
designed to cover a large spectrum of oil and coolant mist
applications. The application will determine the type of mounting
system needed. The most common is the machine mounted Collector.
In most cases this will work because of the small footprint of the
Collector. The CFX Series units also have the ability to be ducted to
one or several machines saving money and floor space.
Machine Mounting Installation:
This is the typical installation type and the simplest set-up when
space permits;
First locate a suitable mounting location on the top of the machine
where the Clarion unit can be mounted.
Many CNC machines have a cover plate along the top or side that
is designated for attaching a filtration flex hose. Locate this if
applicable. The cut-out under the cover plate should be about 6”-8”
diameter but will depend on the size of the machine.
The Clarion unit has a side inlet opening where the mist laden
air enters into the Collector. Locate a level place along the top of
the CNC or machine that will allow a short flexible duct or rigid
metal duct connection from the Collector to machine. This distance
should be as short as possible.
Do not locate the suction intake
on machining applications in direct line of the cutting
spray.
Remove the cover plate from the machine (if present, alternatively
cut a circular opening through the machine skin to suit the flange
size), and install an angle flange (see Figure 4).
Secure the Clarion Unit to the top of the machine that will allow a
minimum of 12” clearance under the Collector (see Figure 5). This will
be for the drain hoses (Detailed in the following section).
FMC-1100 on CNC OpMan
A
DETAIL A
SCALE 1 / 9
A
FIGURE 4
FIGURE 5
DETAIL A
SCALE 1 / 9
A
FIGURE 6