Robotronics Patches & Pumper, Руководство по эксплуатации

Страница: 8 / 63

4
Chapter 1 Getting Started: Setup and How to Operate the Robot
SETUP AND HOW TO OPERATE THE ROBOT
Step # 1 Read the manual
Read and study this manual completely before operating the robot.
Step # 2 Charge and install the batteries
Be certain that the robot battery and radio control transmitter battery are fully charged before
operating the robot. Install the robot battery as follows:
Installing the robot battery:
1. Position the battery so that the posts face the rear of the robot. In this position, the
battery wire will naturally run to the robot battery connector.
2. Connect the robot battery connector to the robot connector. Red will go to red and black
to black. This connection is polarity protected and can be connected only the correct
way.
3. Secure the battery in place with the battery strap. Adjust the clip on the strap if
necessary so that when you put the two clips together, the strap is holding the battery in
place tight.
!
CAUTION
The robot battery posts should never contact the metal of the main electronics box or
the metal of the drive base. This will result in damage to electronic components
especially inside the main electronics box.
Step # 3 Install the upper robot on the lower
1. Set the upper robot on the lower robot body.
2. Locate the four body latches and push the pins into the body to secure the upper robot
to the lower. Two of the latches are located in the compartment where Patches sits.
The pins are to the left and right of Patches. The other two are at the back of the robot.
To latch these you will need to reach in through the back hatch/trunk.
3. Connect the 37 pin connector which is a round connector and wire bundle running from
the upper robot to the lower robot. When connecting this rotate it until it sits down into
its mate connection and turn the ring until it is secure.
!
CAUTION
Before operating the robot or transporting the robot on the cart or in a vehicle; the
upper robot must be properly latched to the lower by pushing the latch pins in.
Failure to do this could cause damage to the upper robot if it fell off.
Step # 4 Voice System Set Up
Put 9-Volt batteries in the voice units (Eveready Alkaline fit tighter). Make sure you follow
the polarity sticker. Put the units on opposite sides of your waist. Plug the headset into the
units. On the 151 Receiver the plug goes into the headphones jack. Adjust the voice
system volume control to the level you want. The voice speaking volume adjustment is
inside the trunk on the voice receiver. The hearing volume level is adjusted on the 151
Receiver that you wear. The Nady 331 Receiver in the robot should have the antenna
extended all the way out.