Robotics Bigmow, Руководство пользователя

Страница: 25 / 28

BIGMOW
Problems Situation Solution
1 The machine operates in
reverse
1 Bonnet position connectors clogged
up
1 Clean between the connectors and
chassis
2 Protective flange connector in contact 1 Press along full length of flange
from top to bottom to disconnect
2 Remove flange connector and test
without the connector. If the
problem persists, it is being
caused elsewhere in the machine.
If necessary, consult your local distributor
2 The machine constantly moves
slowly
1 The sonar is clogged (or damp, having
come into contact with water)
1 CAREFULLY clean the inside of the
sonar, including the inside of both
“eyes”
2 Interference 1 There is something in close
proximity reflecting the sonar’s
waves (on the bonnet?)
3 The sonar is out of position 1 Check that the sonar in properly
positing in its setting
4 The sonar is defective 1 Have it changed by a technician
If necessary, consult your local distributor
3 The machine is systematically
moving in squares
1 The grass is too long in one spot and
the machine is systematically dealing
with it.
1 Simply check that the grass in the
mowing area is not too long. If this
is the case, the user must start by
mowing at a greater height and
gradually lower the cutting heads
until the desired grass length is
achieved (this may take several
days)
If necessary, consult your local distributor
4 Machine Alarm Message:
Head blocked
1 The cut grass was too long and has
clogged up a cutting head
1 Clean the cutting head in question
2 Cutting motor is defective 1 Consult your local distributor, who
will change the defective
component
5 Machine Alarm Message:
Wheel blocked
1 The wheel is blocked by an object (e.g.
a branch)
1 Remove the object in question
2 Motor is defective 1 Consult your local distributor, who
will change the defective
component
6 Machine Alarm Message: Wire
not found
1 The recharging station is disconnected 1 Reconnect the plug
2 Wait for the network to become
live again
2 The wire has been cut 1 Call the local distributor to repair it
7 Machine Alarm Message:
Blocked
1 The machine is stuck between several
obstacles
1 If there are objects obstructing the
path and blocking manoeuvres,
2 The machine has a number of
magnetic field actions; check that
there are no metal objects in or on
the ground
If necessary, consult your local distributor
PAGE 25