Robotics Bigmow, Руководство пользователя

Страница: 16 / 28

Using
BIGMOW :
BIGMOW : Recharging
Charging the battery
When using Bigmow for the first time, place it
on the recharging station for an initial battery
charge (the Bigmow is delivered with an un-
charged battery for safety reasons). The first
charging will take longer (approximately 3
hours). Recharging in normal operation takes
approximately one and a half hours. It is possi-
ble to speed up the recharging process (in
BOOST mode) by selecting the
O000: ) option.
In this mode, one hour of recharging gives one
hour of operation.
In continuous operation mode, the Bigmow will
automatically recharge itself when its battery
charge level falls too low. Once the battery is
recharged, the Bigmow begins a cycle again
(one mow + one recharge) If, during a cycle, the
resistance of the grass is weak (which means
the grass has not grown much), the Bigmow will
wait a few hours before starting again. In this
way, it will work only when needed.
If the Bigmow has not returned to recharge
automatically, or after a long period in storage
(after winter), it may be that the display remains
inactive after pressing ' ' . In this case, take it
to the recharging station and put on charge
manually (contact). If, after ten minutes, there is
still no display, refer to the “Troubleshooting”
section. If this fails please contact your local
distributor.
The Bigmow is configured in the factory with standard parameters. When the property presents
certain characteristics, it is advisable for your local distributor to configure the Bigmow for your
property conditions.
When the peripheral wire (see “peripheral wire” section) and the recharging station (see
“recharging station” section) are correctly connected, you may put the Bigmow into operation.
BIGMOW
Position in recharging mode
1. Place Bigmow on recharging station
2. Switch the power switch to ‘ON’
3. Press ‘ ’
4. Enter your code followed by ‘#’
5. Leave to charge
Charging
PAGE 16