Roboscan PRO 1220, Руководство пользователя

Страница: 11 / 13

REMOVING MODULES
The Roboscan PRO 1220 has been constructed with ease of servicing and maintenance in
mind and is constructed totally in a modular fashion. If you have problems with any
particular section, you want to put in your own custom gobos or you need to clean parts of
the unit it is a simple operation to remove any module, simply :
Remove the top cover of the unit as described in the section marked ’INSTALLING
THE ROBOSCAN PRO 1220’.
Locate the module that you wish to remove from the unit. On this module you will see
that there are Three PCB Connectors connecting the module to a wiring loom, remove
these Three connectors taking care to note the location and direction of each one.
On each side of every module there is a finger screw, unscrew these Two screws and
the module can be removed, to do this simply pull each side of the module straight out
of the unit being careful as you lift.
REPLACING MODULES
To replace the module simply reverse the steps above being careful when you replace
the module to ensure that it is straight and locates properly, there are Two brass pins
on the bottom of the module which have to locate into holes in the bottom of the inner
casing before you are able to re-tighten the finger screws.