Robopac S6, Руководство по эксплуатации и обслуживанию, Страница: 35 / 94

ROBOT S6
300% (∗) (∗)
(∗) See spare parts catalogue.
15. Assembly the small plate and correctly fix it to the gear of the new driving ratio.
16. Assembly the gear of the new driving ratio.
17. Position the gear with the side of the small plate coupled to the friction.
18. Assembly the stopping ring.
19. Assembly the gear of the new driving ratio.
20. Assembly the stopping ring.
21. Assembly the pulley.
22. Assembly the stopping ring.
|
Important
During re-assembly remember to pay attention to the proper insertion of the coupling tabs.
23. Rest the disk on the little columns paying
attention to assemble the belt on the
pulley.
24. Tighten screws (E) .
25. Tension the belt through the tightener.
26. Rotate manually the pre-stretch rollers in
both directions to completely adjust the
coupling between the belt and the
pulleys.
27. Again check the tension of the belt and if
needed strain it properly.
28. Re-assemble the casing (A) at the end of
the operation.
5.5. REEL CARRIAGE LIFTING
CHAIN ADJUSTMENT
Proceed as indicated.
1. Lift the spool carriage (with machine
operation set to "manual mode") up to
"top" end stroke.
2. Switch the machine off.
3. Remove the guard (A) .
4. Loosen the nuts (B) .
5. Screw on the screw (C) "M8x50 UNI 5739" with a tightening torque of 3 Nm on the chain tensioner
(D) .
The screw and the torque wrench are not supplied.
35/94