If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
16
Manual tuning - FM
1. Fully extend the wire aerial located on the rear of your radio. Place
the wire antenna so that it is as straight as possible extending either
above or below the radio.
2. Press
the
On / Off
button to switch on your radio.
3. Press and release the
DAB / FM
button until the FM band is selected.
4. Rotate
the
Tuning / Select
control to tune to a station. The frequency
will change in steps of 50kHz.
If the radio is tuned to a station of suf
fi
cient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Set
the
Volume
to the desired setting.
7. To switch off your radio press the
On / Off
button.
Note:
If you
fi
nd that FM reception is poor, try repositioning the wire aerial. Fully
extend the wire aerial located on the rear of your radio. Place the wire
antenna so that it is as straight as possible extending either above or
below the radio. If you
fi
nd that an FM broadcast has a lot of background
hiss, this may often be reduced by setting the radio into Mono reception
mode for the current FM station. Please refer to the section "Stereo / Mono
setting - FM" on page 18 for further details.
3
2,7
6
4
