15
Operating your radio - FM auto-tune
1. Fully extend the wire aerial located on the rear of your radio. Place
the wire antenna so that it is as straight as possible extending either
above or below the radio.
2. Press
the
On / Off
button to switch on your radio.
3. Press and release the
DAB / FM
button until the FM band is selected.
4. Press and release the
Auto Tune
button to cause your radio to search
from low frequency to high frequency and to stop automatically when
it
fi
nds a station of suf
fi
cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio may display the station name.
6. To
fi
nd other stations press and release the
Auto Tune
button as
before.
7. Press and hold down the
Auto Tune
button for 2 - 3 seconds to cause
your radio to search from high frequency to low frequency and to stop
automatically when it
fi
nds a station of suf
fi
cient strength.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust
the
Volume
to the required setting.
10. To switch off your radio, press the
On / Off
button.
4-7
3
2,10
9
Note:
If you
fi
nd that FM reception is poor, try repositioning the wire aerial. Fully
extend the wire aerial located on the rear of your radio. Place the wire
antenna so that it is as straight as possible extending either above or
below the radio. If you
fi
nd that an FM broadcast has a lot of background
hiss, this may often be reduced by setting the radio into Mono reception
mode for the current FM station. Please refer to the section "Stereo / Mono
setting - FM" on page 18 for further details.
