Robe ROBIN SilverScan, Руководство пользователя

Страница: 9 / 44

9
4.3 Replacing the frost
Install the frost module with the device switched off only.
Unplug from mains before!
To replace the frost module.
1. Disconnect the fixture from mains and allow it to cool for 10 minutes.
2. Remove the bottom plastic cover of the fixture by loosening the 4 quarter-turn fasteners on the cover.
3. Remove the shield cover (1) by unscrewing the fourth screws (2) with washers to get access to
the frost module (3).
4 . The holder (4) of the frost film is fastened to the frost holder (5) by means of the four magnets (6). Grip the
holder (4) and carefully tilt it out to break a force of magnets (6) on the frost holder (5).
5 . Insert a new frost module into the frost holder (5). Check, that both slots (7) snapped correctly into
two protrusions (8) on the holder (5).
6. Screw the shield cover (1) back to the fixture chassis and place the plastic cover back on the fixture before
applying power.