Robe Robin miniPointe, Руководство пользователя

Страница: 26 / 38

26
SENSOR_VALUE *
DISPLAY_INVERT * *
DISPLAY_LEVEL * *
PAN_INVERT
* *
TILT_INVERT * *
DEVICE_RESET *
DMX_PERSONALITY * *
DMX_PERSONALITY_DESCRIPTION *
STATUS_MESSAGES *
STATUS_ID_DESCRIPTION *
LAMP_STATE
* *
LAMP_ON_MODE
1
* *
DEVICE_HOURS
2
*
LAMP_HOURS
2
*
LAMP_STRIKES
2
*
1
...Another options for this command (only for Robe´s fixtures):
value PARAMETER_DATA=0x84 - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x88 - lamp OFF if DMX is not present
2
...Commands relative resetable values
8. Error and information messages
Lamp Err (Lamp Error)
If the ignition of the lamp is 4 times unsuccessful , the display shows “LampErr”, meaning that the lamp could
be damaged or even missed or there could be a failure on the lamp driver.
Ovh Err (Overheated)
This message informs that the fixture had been overheated and the lamp was switched off by means of the
head temperature sensor.
Temp Err (Temper.Sensor Error)
The message informs you that the communication betwen the head temperature sensor and the main processor
failed and the lamp has been switched off.
Tilt Err (Tilt Error)
This message will appear after the reset of the fixture if the tilt sensor sensor failed or magnet is missing or the
stepping motor is defective or its driving IC on the PCB. The head is not located in the default position after
the reset.
Pan Err (Pan Error)
This message will appear after the reset of the fixture if the pan sensor failed or magnet is missing or the
stepping motor is defective or its driving IC on the PCB. The yoke is not located in the default position after the
reset of the fixture.
CWh Err (Colour Wheel Error )
The messages will appear after the reset of the colour wheel if this wheel is not located in the default position.
StG Err (Static Gobo Wheel Error )
The messages will appear after the reset of the static gobo wheel if this wheel is not located in the default position.