28
-
Presetting playback
This function allows you to select the the program which will be played in the stand-alone mode after switching
the fixture on(
LAAu-
function must be "
On
" in the menu
LAPr)
.The selected program will be also used for the
operating with the time periods or the light level period(
LAAu-
function must be "
OFF
" in the menu
LAPr)
.
Use the
[Up]
and
[Down]
buttons to select desired program ("
tESt
"- bilt-in program) or
"OFF"
if you don't want to
trigger any program and press
[Enter]
to confirm or
[Mode]
to cancel and return to the menu.Selected program
will be played continuously in a loop as long as it appears on the display.
This option should be set "
OFF
" for all slaves in the master/slave chain by reason of the right program starts.
For example: You have selected program "
PrG.3
" in this menu and:
This fixture is set as a single fixture (master/slave or controller operating)- the fixture will run its program "
PrG.3
".
This fixture is set as a master in a data chain- the fixture will run its program "
PrG.3
".
This fixture is set as a slave in a data chain- the fixture will run its program according to the master(if the master
runs its own program "
PrG.1
", the slave will run its own program "
PrG.1
"also).
Note for the controller mode:
If the fixture operates in this mode ( DMX controller is connected) and any
program from this menu is selected ,the fixture will start to play the selected program if:
- the fixture is switched on
- the reset command from DMX controller is received
- the timer or light level trigger are active and starts the operation
In all these cases the fixture will not respond to the DMX controller.
-
Timer
By this menu you can set one or two periods during a 24 hour time period for the stand-alone operation.For
example ,one period in the morning and one period in the evening.
-
Fixture clock
This function allows to set the current fixture time. Use the
[Up]
or
[Down]
buttons to set the
hour and press
the [Enter]
-button.Use the
[Up]
or
[Down]
buttons to set the minutes and press the
[Enter]
-button to save the adjusted time or press the
[Mode]
-button
twice to cancel and return
to the menu.
.
-Timer 1 -start
This function sets the start of the time period 1.Use the
[Up]
or
[Down]
buttons to specify the
start hour and press the
[Enter]
-button.Use the
[Up]
or
[Down]
buttons to specify the start minute
and press
[Enter]
.
-Timer 1-stop
This function sets the finish of the time period 1.Use the
[Up]
or
[Down]
buttons to specify the
stop hour and press the
[Enter]
-button.Use the
[Up]
or
[Down]
buttons to specify the stop minute
and press
[Enter]
.
If you wish to deactivate the Timer 1,set Ont1="Off" and OFt1="Off".
