24
- Lamp On after switching the fixture On
This function enables to turn the lamp on automatically after switching the fixture on. Use the
[Up]
and
[Down]
buttons to select
"On"
if you wish to turn the lamp on automatically after switching the
fixture on or
"Off"
if you wish the lamp off after switching on the fixture and press
[Enter]
to
confirm or
[Mode]
to cancel and return to the menu.
- Lamp Off via DMX
This function allows you to switch off the lamp by DMX. Use the
[Up]
and
[Down]
buttons to select
"On"
if you want to switch off the lamp by DMX or
"Off"
if you don’t want to switch off the lamp by
DMX and press
[Enter]
to confirm or
[Mode]
to cancel and return to the menu.
- Lamp On if DMX is present
This function allows you to strike the lamp automatically after 26 s if DMX signal is present on
the data link.If the ignition is unsuccessfull (e.g.lamp is too hot),the fixture will try to ignite the
lamp after next 26 s.This process will repeat until the lamp lights. Use the
[Up]
and
[Down]
buttons
to select
"On"
if you want to strike the lamp or
"Off"
if you don’t want to strike the lamp and press
[Enter]
to confirm or
[Mode]
to cancel and return to the menu.
- Lamp Off if DMX is missing
This function allows you to switch Off the lamp automatically after 2 minutes if DMX signal is
missing on the data link. Use the
[Up]
and
[Down]
buttons to select
"On"
if you want to switch Off
the lamp or
"Off"
if you don’t want to switch Off the lamp and press
[Enter]
to confirm or
[Mode]
to cancel and return to the menu.
- Switch On/Off the lamp light sensor
Use the
[Up]
and
[Down]
buttons to select
"On"
if you wish to switch the lamp light sensor on and press
[Enter]
to confirm or
[Mode]
to cancel and return to the menu.
The option"On" is for the standard operation.
Use the
[Up]
and
[Down]
buttons to select
"Off"
if you wish to switch the lamp light sensor off and press
[Enter]
to
confirm or
[Mode]
to cancel and return to the menu.
Important:
The option"Off" is for "emergency operation" only if the lamp light sensor is defective and
you will wait for a service intervertion!
If the lamp light sensor is switched Off,the error messages
"
LAEr,SnEr,HEAt
" will not appear on the display (only the message "HEAt" will appear if the lamp was turned off
and on within 5 minutes ) and at switching the lamp On the electronics will still try to ignite the lamp until it shines
(even when the lamp is damaged or absent), on this account some electronics parts could be damaged!
- Display adjusting
This function allows you to adjust the display settings:
