Robe CitySource 96 WDMX, Руководство пользователя

Страница: 8 / 27

CitySource 96 (RGBW)
8
3.4 Installation of the barn-doors and top hat/half top hat
You can install the barn-doors or top hat/half top hat to better define illuminated surface.
1. Disconnect the fixture from the mains.
2. Remove the eggcrate lens module 25°(2) by unscrewing the four M5x14 screws (1) including washers (3).
3. Place the barn-doors module (4) or top hat/half top hat on the eggcrate lens module 25° (2) and screw
them on the fixture using four M5x14 screws (1) and washers (3) as shown on the picture below.
Never close the barn-doors during fixture operation
3.5 DMX 512 connection
The fixture is equipped with two 5-pin XLR connectors for DMX input/output. Only use a shielded twisted-pair
cable designed for RS-485 and 5-pin XLR- connectors in order to connect the controller with the fixture or one
fixture with another.
Wiring of the XLR connectors:
DMX output DMX input
XLR socket (rear view): XLR plug (rear view):
1
– Shield
2
- Signal (-)
3
- Signal (+)
4
– Not connected
5
– Not connected