8
9
5. Installation
5.1 Connection to the mains
Verify the power supply settings before applying power!
The factory settings are printed next to the power switch. If you wish to change the power supply settings, see the next
chapter.
Installl a 3-prong grounding-type plug on the power cable (only for US version 208V AC/60Hz). The earth has to be con-
nected!
If you have any doubts about proper installation, consult a qualified electrician.
The occupation of the connection-cables is as follows:
Cable (EU) Cable (US)-208V Pin
International
Brown
Black
Live
L
Liht blue
White
Neutral
N
Yellow/
Green
Green
Earth
5.2 Changing the power supply settings
Magnetic ballast
The wrong settings can cause poor performance or demage of the moving head.
Note:
The US-version settings is 208V AC interphase, 60Hz.
If you want to change the power supply settings, follow the instructions:
1. Disconnect the fixture from AC power.
2. Remove the both top base covers by loosening the 12 screws.
3. Move both wires (1) and both wires (2) on
the ballast connection block to the position according to the desired voltage.
(The fixture contains 2 magnetics ballast connected in parallel). Move the wire (3) on the transformer connection block
to the position according to the desired voltage.
4. Close the base before applying AC power.
Ballast/transformer connection block:
Power supply settings: 230V/50Hz
