ROBBE Arcus II 2649, Инструкция и руководство пользователя

Страница: 20 / 24

ENGLISH
20
INSTRUCTIONS AND USER MANUAL
5. Programming the ESC with the transmitter (4 steps)
Note:
Please note that the throttle curve is set to 0%, the throttle lever to neutral position and the deflection to 100%.
1. Start programming mode
2. Select program point
3. Setting the program point (value)
4. PExit programming mode.
4. Exit programming
There are two ways to exit the programming:
1. In step 3, after the special tone "♪1515", move the throttle stick to the neutral
position within 2 seconds.
2. In step 2, after tone "beep-----beep " (e.g. point 8) bring throttle stick inner 3 sec.
Into neutral position.
(1short tone)
(2 short tones)
(3 short tones)
(4 short tones)
(1 long tone)
(1 long 1 short)
(1 long 2 short)
(2 long tones)
4. “beep-beep-beep-beep- ” Cut-Off volt.
5. “beep----- ” Start Mode
6. “beep-----beep- ” Timing
7. “beep-----beep-beep- ” Factory reset
8. “beep-----beep----- ” Exit
Brake
Batt. type
Lower volt.
1. “beep”
2. “beep-beep- ”
3. “beep-beep-beep- ”
2. Select program point
After starting the programming mode you will hear 8 tones in a loop with
sequence. If you move the throttle to the neutral position within 3 seconds after
listening to a tone, this point will be selected.
3. Setting the program point (value)
You hear different tones in a loop. Set the value by tone by moving the throttle to
full throttle. Then you h ear a special tone "♪1515" which confirms and saves the
selection. (Holding the throttle to full throttle brings you back to step 2 and you can
select another point. Moving the throttle lever to the neutral position within 2
seconds will exit the programming mode.)
Point Tone
“beep-” “beep-beep-” “beep-beep-beep”
1 short tone 2 short tones 3 short tones
Brake Off On
Battery type Lipo NiMH
Cut-Off Soft-Cut Cut-Off
Cut-Off voltage Low Medium High
Start mode Normal Soft Super Soft
Timing Low Medium High
1. Start programming mode
1) Switch on transmitter, set throttle stick to full throttle, connect battery to ESC
2) Wait 2 sec., a double „beep“ must be heard
3) Wait another 5 sec., special tone like “♪56721” should be heard. This
confirms the programming mode.