ENGLISH
11
INSTRUCTIONS AND USER MANUAL
OPTIONAL: Retrofitting with flaps
3. Procedure for installation of flaps
Pictures 1 and 2:
Cut the ailerons in the width of the formed dividing line (1-2mm) up to the hinge.
Picture 3:
A sharp cutter knife is used to cut out the
covers of the installation housings for the flap servos on
the underside of the wings, left and right. Attention,
these covers are 2-3mm thick, do not cut too deep.
Picture 4:
Then glue the rudder horns into the formed recess of the
flaps. Use a suitable adhesive (e.g. 5-minute epoxy).
Observe the safety and processing instructions of the
adhesive manufacturer.
Make sure that no glue runs into the hinge.
Picture 5:
Attach a small weight to the end of an approx. 350mm
long string.
Picture 6:
Thread the string with the weight in front into the cable
guide of the wing. It is required for the additional servo
cable.
6
5
4
3
2
1
