ENGLISH
15
INSTRUCTIONS AND USER MANUAL
Flight preparations
Perform a functional check of the model before each flight.
Make sure that all rudders run in the correct direction and align correctly with the
surfaces, and that the motor rotates in the correct direction.
Rudder function check
When the aileron is actuated to the right, the right aileron must lift and the left aileron
must lower. When actuated to the left, the rudder movements are reversed. When
the rudder is actuated to the right, the rudder must deflect to the right. When the
rudder is actuated to the left, it must deflect to the left.
Pull the stick for the elevator towards you (below), the elevator must move upwards
(climb). Push away the stick, the elevator must move downwards (descent).
Motor function check
The engine must turn to the right when the throttle stick is actuated upwards, seen in
flight direction.
When checking the motor, make sure that the model cannot move away, that
nothing blocks the propeller or the motor, and that you do not reach into the rotating
area of the propeller or into the running propeller. Risk of injury!
Divergences
If deviations are found during the functional check, the correct connection of the
servos, the controller and the motor must be checked. If necessary, reverse the
running direction of the servos via the remote control system (servo reverse). The
running direction of the motor can be changed by exchanging 2 of the 3 connecting
cables to the controller.
Also always check that the propeller and the motor are seated correctly.
Caution! Observe the connection diagram and operating instructions for the
individual components of the manufacturer!
Correct procedure before the start
1. make sure that the flight battery and the transmitter are charged.
2. choose a day with absolute wind direction or light wind only.
3. turn the speed stick all the way down and switch on the transmitter.
4. Connect the flight battery as described.
5. The transmitter and receiver are ready for operation, repeat this procedure each
time the aircraft is put into operation.
If the propeller turns, this must be balanced with the speed trim until the
propeller comes to a standstill.
Correct procedure after landing
1.
Remove the flight battery and disconnect from the ESC.
2.
Switch off the transmitter.
Please observe the safety instructions on pages 2 and 3!
