a
SAFETY
a
GENERAL SAFETY
This machine contains no user-serviceable parts. Roband Australia, one of
our agents, or a similarly qualified person(s) should carry out any and all
repairs. Any repair person(s) should be instructed to read the Safety
warnings within this manual before commencing work on these units.
Steel cutting processes such as those used in the construction of this
machine result in sharp edges. Whilst any such edges are removed to the
best of our ability it is always wise to take care when contacting any edge.
Particular care should be taken to avoid contact with any steel edge, and
warnings should be given in regards to the danger of such contact to any
repair or maintenance person(s) prior to commencement of any servicing.
Do not remove any cover panels that may be on the machine.
National Standards exist outlining the positioning, spacing and ventilation
requirements when installing new appliances. These Standards should be
consulted and new equipment should be installed accordingly. In any
situation where specifications allow a distance of less than 100mm we
would still recommend that a well-ventilated air gap of not less than 100mm
be maintained on all sides. If the machine is near particularly heat-
sensitive materials common sense should be employed in determining
sufficient distancing.
Ensure that any damaged cables are replaced before further use.
Keep this unit out of reach of children.
This unit can get
very
hot. Ensure everyone is aware that the machine is
operating and take care to avoid contact with hot surfaces.
Always ensure the power cable is not in contact with hot parts of the
machine when in use.
Page
8
Electricity is dangerous, a
nd should only be handled by
qualified professionals. It’s
your life – D
on’t risk it.
