Page
6
INSTALLATION
Remove all the packaging materials and tape, as well as any protective
plastic from the machine. Clean off any glue residue left over from the
protective plastic or tape. In general the lamps should be mounted so as to
be roughly 320-450mm above the level of the product to be heated.
Caution for all models:
The tungsten halogen lamps fitted to these units
should not be touched with fingers as this could reduce the life of the lamp.
Always use a clean, dry cloth to remove and replace the lamps. It should
be noted that, with the lamps wired in series, if one lamp happens to fail,
both
lamps will go out. Look carefully at the lamp filament spirals to
determine which one is broken before removing.
For models HL22, HL24 & HL26
These units
must
be installed as pairs, wired in
series
and each model
must only be paired with itself ie, a HL24 must be paired with another
HL24. Due to the variety of installations possible in the field, we are unable
to give specific instructions on installation. However, the units must be
mounted using the mounting bolts on the back of the fitting and the brass
spacer nuts must be left in place to stand the units off the surface they are
being supported by, to ensure adequate ventilation. As ventilation is most
important to dissipate heat, the units should not be fully “boxed in”.
The units should be installed and wired by a
licensed electrician.
For model HL90, HL120, HL150
These units are designed to be mounted above food serving and
preparation areas providing a heat/light source.
To mount, unscrew the screws on each side of the unit, and attach through
the holes provided in the top section. Replace the bottom section with the
electrical components into the top section and replace the screws. Connect
to a standard single phase 10 amp outlet with the cord provided and
operate the switch located on the end of the unit.
For model HL30
This unit has been designed as a heating station providing a heat/light
source. Applications include the following and other uses:
Carving station,
food preparation,
food warmer,
self serve display heating
Connect to a standard 10 amp single phase outlet and turn power on at the
front of the machine.
