Roadtrek Inc.
38
City Water (Continued)
To connect the Roadtrek's water system to an outside source:
•
Turn the water pump off.
•
Close the city tank fill valve by turning the handle to the vertical position. (Picture 39.1)
•
Close all interior faucets.
•
Flush old water and any contaminants out of the water supply faucet.
•
Connect your freshwater hose to the faucet.
•
Attach your pressure regulator to the Roadtrek's city water connection.
•
Attach a freshwater hose to the pressure regulator.
•
Slowly open the faucet of the city water source.
•
The city water connection by-passes the water pump and freshwater tank. Therefore, the
use of these items is not necessary when connected directly to an external water source.
To disconnect the city water connection:
•
Turn off the external water source.
•
Open a faucet to relieve the pressure in the system. Failure to do so will not damage your vehicle but may result in an unexpected shower.
The galley sink is a convenient place to do this.
•
If you used the City valve to fill the tanks, close it.
•
Remove the hose from the city water connection and replace the cap on the fill connection.
If you hear your pump running and water pressure is low inside the vehicle after disconnecting from an external water source, it is because
you have not properly positioned the city water valve. Make sure the black plastic handle is vertical, and perpendicular to the water line when
your water system is in self-contained mode.
See HOWTO: Potable Water Use for more information on your fresh water
Picture 39.1
Содержание SS AGILE 2020
Страница 1: ...2020 O WNE R S MAN UAL www roadtrek com...
