CD240MPR/512
10
Inserting and connecting the unit
1. Where possible use the strap to
support the back of the unit.
2. Bend the strap (by hand) to the
desired angle to reach the
surrounding structure. Fit to the car
structure using the fixings provided.
3. Connect the ISO connector plug to
the car ISO socket. Plug the aerial
lead in.
4. Slide the unit into the sleeve and
secure the strap to the stud on the rear of the unit using the plain
washer and nut supplied.
Removing the unit
1. Switch the ignition key off
2. If the strap was used to support the unit, remove this first.
3. Insert the release keys into the groove on each side of the unit until
they click. Pull the levers out with the unit to remove it from the
sleeve in the dashboard.
Initial switching on and off
Reset the unit first
Reset the unit by briefly pressing the
RESET
button with a ball point
pen. The unit is now reset to the factory defaults,
After a reset the unit will initially switch on in radio mode.
Switch the unit on/off
Press the
PWR
button on the front panel. The LCD display will light up
with the message WELCOME followed by FM1 87.50. Press the PWR
button again to switch the unit off
