ASSEMBLY INSTRUCTIONS — WIDE AXLE
3
The wide axle setup is the most versatile, since the
ramps can be adjusted to accommodate either narrow
or wide vehicles.
Note: if the tow dolly axles are changed from wide
to narrow, or from narrow to wide, the tow dolly must
be realigned. See the section titled “Alignment instruc-
tions.”
1
A
Start by opening the box and unloading everything
except the main bed of the dolly. Tear the walls of the
box down and place solid wooden blocks or stands
underneath each side of the frame so that the bottom
of the main bed is about eight inches off the ground.
Now, use the “Axle and Ramp Positioning Chart”
on page two to measure the overall tread width of the
vehicle to be towed, and to determine the position for
the axles and ramps.
2
A
Attach one of the axles — Starting on one side, pull
Use these instructions ONLY for wide axle assembly
the axle out so the three holes in the top of the axle
align with the three holes identified as
W5
,
W6
and
W7
in Figure 1. Insert ½" x 4½" bolts with washers through
W5
,
W8
and
W9
. Install washers and lock nuts on the
opposite side. Do not insert bolts through
W6
or
W7
at this time.
3
A
Attach one of the ramps —
When installing the ramps, use extreme caution
not to pinch, crush, cut or otherwise damage the
attached wiring or plugs. If electrical components
are damaged, they will not function.
Since the axle is being assembled in the wide set-
continued on next page
Figure 1
