RMG TRZ 04, Руководство по эксплуатации

Страница: 17 / 60

Installation and Commissioning
................................................................................................................................................................................................
................................................................................................................................................................................................
Manual TRZ 04 · EN04 · February, 1st 2017
14

Accuracy
 
0.5% (above 0.2 Qmax)

Blade monitoring system
TRZ 04-K

For secondary metering.

Installation length:

1.5 x DN (DN 50: 3 DN)

Accuracy
 
1% (above 0.2 Qmax)
The following applies to all meter types:

Maximum operating pressure: 100 bar (not for gas meters with a plastic turbine wheel)

Meter sizes from G 65 to G 1600

Measuring range 1:20 at operating pressure p
m
= 1 barg;

Measuring range up to 1:100 at p
m
>= 3 barg (see table: Q
min
depending on p
min
)

Connections in compliance with DIN or ANSI are available

Special designs for aggressive gases are available

Available for low temperatures (< - 20°C)

All gas meters can be operated in any position up to the nominal diameter of
DN 200.
Notice
The meters with nominal diameters from DN 50 to DN 200 are approved
for custody transfer metering (up to G 1600).
The nominal diameters from DN 250 are special versions without MID
approval for which RMG does not guarantee the availability (only on
request).
The TRZ 04 and TRZ 04-K are approved for the use in explosive areas; the indication is:
II 1G Ex ia IIC T4
(HF-Sensors)
II 2G Ex ib IIC T6
(Encoder)
The corresponding conformity certificates can be found in the appendix.
Introduction