RMG TME400-VM, Руководство по эксплуатации

Страница: 66 / 137

4 Operation
Manual TME400-VMF · EN07 · December, 7
th
2020
60
A22 Digital output 2
pulse width
20 ms
125 ms (default)
250 ms
A12 Meter factor corrected
The meter can be adjusted by the operator, e.g. during calibration.
This value does not change.
Coor-
dinate Name Modbus
register Modbus
access Protec-
tion Data
type Min. Max. Default Unit
A02 Operating volume
302 W
E
uint32
0
99999999
0
m
3
A05
Uncorrected operating
volume 308 W
E
uint32
0
99999999
0
m 3
A06 Volume Start/Stop
310 W
N
uint32 0
99999999
0
m 3
A07 Volume Reset
312 W
N
uint32 0 99999999 0
m 3
A10 Meter factor
500 W
E
string12 * * 1000.0 I/m
3
A11 Output pulse factor
506 W
E
float 0.01 100 1.0
I/m 3
A20 Display factor
510 W
E
menu16 0 4 2
A22
Digital output 2 pulse
width 512 W
N
menu16
0 2 1
ms
A12 Meter factor corrected
508 R
A
float - - 1.0
I/m
3
4.3.3.2.
Flow rate
Coordi-
nate Name Description
B02 Operating flow rate Flow rate under current operating conditions
B03 Frequency Unchanged output value, frequency of Sensor 1.
B05 Min. flow rate an alarm is generated below this flow rate
B06 Max. flow rate an alarm is generated above this flow rate
B10,
B11,
B12,
B13;
B14;
B15 Coefficients:
A-2, A-1, A0, A1, A2
Max. operating point
deviation Z26:
If the characteristic correction is deactivated, the additional parame-
ters are not visible and cannot be adjusted. If a characteristic correc-
tion is activated (see Z26 below), a correction takes place with the
factors in:
B10: Factor for the characteristic correction
B11: Factor for the characteristic correction
B12: Factor for the characteristic correction
B13: Factor for the characteristic correction
B14: Factor for the characteristic correction
B15: If the deviation of the corrected from the uncorrected character-
istic at an operating point (or a range) is more than the adjusted
value (2% here), the correction, is set to "0" for this operating point
or operating range, which means a correction takes place.
B08 Leak flow volume limit The flow rate is disregarded below this leak flow volume limit - i.e. it
is set to 0