RMG TME400-VM, Руководство по эксплуатации

Страница: 13 / 137

1 Introduction
Manual TME400-VMF · EN07 · December, 7
th
2020
7
Danger
Inadequately qualified persons working on the equipment are unable to cor-
rectly estimate dangers. Explosions can be triggered. Only work on the
equipment if you have the appropriate qualifications.
Components can be damaged if you do not use suitable tools and materials.
Use tools that are recommended for the respective work in the operating
manual.
Mechanical installation Mechanical installation must only be performed by appro-
priately qualified technicians.
Electrical installation Installation on electrical components must only be carried
out by qualified electricians.
Mechanical and/or
electrical installation These qualified personnel require training specifically for
work in hazardous areas. Qualified personnel are persons
who have training / education in accordance with
DIN
VDE 0105 , IEC 364 or comparable standards .
Danger
Installation and removal of the TME400 must only take place in an explosion-
free, pressure-free atmosphere. The descriptions in the operating manual
must be observed. In general, it is recommended that the replacement should
only be carried out by RMG Service.
A leak test must be carried out after work on pressurized components.
All of the above points also apply to repair and maintenance tasks and in
general when opening the meter is necessary.
Flange fastening elements, fastening screws, screw couplings and check
valves, the oil supply, pressure relief connections, valves, HF pulse genera-
tors, protective pipes and swivel adapters must not be loosened during oper-
ation.
1.2.4.3.
Dangers during maintenance and repair
Operating personnel The operating personnel use and operate the device in
the scope of the intended use.