RMG TME400-VM, Руководство по эксплуатации

Страница: 60 / 137

4 Operation
Manual TME400-VMF · EN07 · December, 7
th
2020
54
Access level Access right
A Display values, change not possible
N Parameter for which no password is necessary for use
C Code word
Entry of a code word is necessary to change the parameter.
E Calibration button
Custody-transfer variant TME400-VMF:
Custody-transfer display values / parameters, use of the
calibration button is necessary.
Non-custody-transfer variant TME400-VM:
Entry of the code word is adequate.
Note
Enabling or disabling the code word or opening the calibration
button creates an entry in the event archive (see below).
4.2. Programming
There are five buttons available on the front foil for programming of the TME400. Al-
ternatively, you can carry out programming via the RMGView
TME
operating software
(see chapter 4.4 RMGViewTME ).
4.2.1.
Programming with the programming buttons
Basically, you proceed as follows for the programming:
•
First check the protection status of the coordinate. When parameters are not
protected, you can carry out changes, as described below without additional
measures.
•
With parameters protected by code word, you must enter it first in coordinate
Z15. Please read how to make the entry as below.
•
With parameters protected for custody-transfer applications, you must press
the calibration button first.