Copyright © 2013 Ready Made RC, LLC
3
6.
Install servo into housing as
shown. Some trimming of
the posts may be required
depending on brand of servo.
-
Install rod into second hole
from the outside.
7.
Connect servo wire and
insert housing into wing.
Keep the servo wire towards
the gap at the back of the
servo to ensure it does not
get caught up when
operating.
-
Secure with fasteners.
8.
Insert push rod stopper into
second hole and secure with
nut. Do not clamp down with
nut. Leave it barely loose
enough to rotate. Use thread
locker on the outside of nut
to secure.
-
Caution: Thread locker can
weaken plastics, so do not let
them come into contact.
9. Partially insert small machined
screw into stopper along with thread
locker. Again, be sure that servo is
at 90* and control surface is flush
with the wing. Insert rod into
stopper.
-
Tighten down on the Phillips
screw while using opposite
hand to support control horn,
preventing tear out.
-
Repeat steps 5-10 on
opposite wing.
