Copyright © 2013 Ready Made RC, LLC
9
30. Dry fit canopy hinge and glue
into place with epoxy. Be sure that
hinge stays in place while it sets.
31. Use epoxy to fasten canopy
magnet into fuselage. Check for
correct polarization first, and cover
with masking tape. Allow to dry
with canopy in place.
32. Carefully slide one wing into
fuselage while aligning with the
frame’s spar opening.
-
Avoid getting the servo wire stuck
in different positions while inserting
wing.
- Make servo connections if you are
using a “Y” harness or feed wires
through fuselage. Slide in spar from
opposite side, followed by
remaining wing.
34. Once wings are fully seated, flip
model over and tighten down on
spar with Phillips screws located
under the wing.
