S6
STEP 7-8 LINKAGE CONNECTION
90º
82mm
RJXHOBBY
Use two large links
and one 60mm rod.
IMPORTANT:
Ensure that the carburator is 50% open
in this position.Readjust the carburator
arm if not.
4. THROTTLE SERVO
5. TAIL SERVO
90º
270mm
RJXHOBBY
RJXHOBBY
RJXHOBBY
Use two large links and the 230mm CF tube
230mm 2x4 Cf Rod
60mm Special Rod
Linkage
P
X
E
O
Y
IMPORTANT:
Use EPOXY to glue the
special rod into the CF tube.
NOTE:
Assembly both side of the CF Control Rod
NOTE: Assembly both sides of the CF Control Rod
Before attaching the Linkage pass the 8mm heatshrink onto the cf rod.
After adjusting the length heat up the shrink covering the begining of the
linkage and the carbon rod.
NOTE:
To avoid differential throttle travel, make certain both the throttle
arm and the servo horn are positioned as shown next in the diagram.
To archieve the correct position of the throttle/servo arm, it may be
necessary to re-position the arm on the carburator and adjust the
length of the throttle linkage slightly to archieve full open and close
positions. It may be necessary to increase/decrease the travel of the
throttle servo through the ATV function in your radio. If this is used,
make sure that the values for the high and low positions remain
equal. If these values are not equal, this will creat a differential or
uneven movement of the throttle, making adjustment and fine
tuning dificult.
Let aprox. 10mm out
of the CF rod from the
Linkage rod
