RIX Industries RIX 2V3B-4.1V Series, Инструкция по эксплуатации и перечень запасных частей

Страница: 34 / 79

MAN-2V3B-4.1V REV (B)
23
7.8 PISTON ROD ADJUSTMENT
a. Turn the flywheel by hand to position the piston at top dead center.
b. Screw the rod out of the guide piston until the piston touches up against the valve.
c. Be certain the piston is still at top dead center, then screw the piston down three quarters
of one turn. The piston-to-cylinder head clearance will be approximately .040 inch.
d. Tighten the jam nut to 25 ft-lbs. torque.
e. Slide the oil wiper box into position, pushing down hard to ensure it is fully seated.
Tighten locking screw hand tight with 7/64" allen wrench (Note: overtightening may
dislodge packing box) and then secure using the jam nut.
f. Turn the flywheel by hand a few revolutions to be certain that everything is clear before
starting the compressor.
Oil Packing Break-In: None required.