TF2002501-RG English
Page 9 of 14
20190611 V.2
Lighting Instructions
1
Open the burner cover.
2
When you are sure there are no leaks, turn cylinder valve and regulator control valve on
hose to the closed position.
3
Reopen cylinder valve fully.
4
Have a standard match, fireplace match or long-nosed propone lighter lit and ready to
place over the burner.
Important: The match should be attached to fire arm during the following lighting
Procedures.
5
Light the burner from the burner top before open the gas supply, keeping hands and face
away from open burner.
6
Place lighted match over the burner open, then slowly open regulator valve until burner
ignites.
7
Adjust the regulator control valve for desired flame height.
8
When finished using the cooker, turn off gas the cylinder valve first. It will take a few
second for the fire to go out and for the propane gas to “bleed” from the hose and regulator
assembly. After the fire is completely out, turn regulator control valve to the “OFF” position.
9
To re-light, repeat steps 1-8, always use
CAUTION
as cooker will be hot.
10 If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and
repeat the lighting procedure.
CAUTION
If burner does not light OR if burner flame is accidentally extinguished, turn knob to OFF,
wait 5 minutes, try again. If the burner does not ignite with valve open OR if burner flame
is goes out after lighting, gas will continue to flow out of the burner and could accidentally
ignite with risk of injury.
Clockwise to
open gas supply
Match
Chain connect to
metal stand
Standard
Match/Fireplace
Match
Lighter Arm
