![background image](http://html1.mh-extra.com/html/riverbed/xh2-240/xh2-240_quick-installation-manual_1465732006.webp)
XH2-240 Hardened Access Points
6
Connect the Ethernet Cable with the Waterproof Connector
NOTE: To disconnect the Ethernet ports at a later time, you must follow the procedure in
Step 10 on page 11
.
Power
: These APs are only powered through the GIG1 PoE+ port.
Data
: Data is supplied to the GIG1-POE+ port via the same cable that powers the AP, and a
second optional connection to the GIG2 port.
NOTE: It is VERY IMPORTANT to assemble the waterproof connector properly,
following the directions below. Failure to do so may expose the AP to the elements, and
may result in an intermittent connection causing the AP to connect at very low speeds!
If GIG2 is not used, you MUST leave its protector cap assembly securely installed.
The Ethernet cable must be terminated with a simple RJ45 plug with the tab exposed, as
shown on the left below. Do not use a plug with a tab protector boot, as shown on the right.
This will not seat properly in the waterproof connector, and the assembly will not be
watertight.
7
Bluetooth Status
LED
GIG1/POE
Ethernet
GIG2
Ethernet
Reset
Button
Ground
Connection
Pressure Equalizer -
(do not disturb this)