36 | Replacing SteelConnect SDI-2030 and SDI-5030 Gateway Components
Installing or replacing network interface cards (NICs)
4. Remove the top cover. Only PCI riser-card slot 1 is configurable in the SDI-2030 and SDI-5030
gateways. (See
“Removing and installing the chassis cover” on page 26
.)
Figure 3-20. PCI risers
To install a card in the PCI riser
1. Remove the riser with the bracket by removing the screw.
2. If you are replacing an existing card, carefully pull the card from the riser. If you are not replacing a
card, remove the filler panel from the slot by pushing it from the inside of the gateway.
3. Hold the new card between the front bezel and the rear of the card to avoid ESD damage.
4. Plug the assembly into the riser slot on the baseboard and fasten the screw.
Figure 3-21. Installing a PCI adapter to the riser assembly
Note:
Make sure the cards are seated properly in the enclosure. The cards are not functional if they are not seated
properly.
