![background image](http://html.mh-extra.com/html/riverbed/nic-lr/nic-lr_installation-manual_1465724104.webp)
104 | Installing NICs in SteelHead xx50 Appliances
Installing NICs in 3U xx50 appliances and Interceptor 9350
9. Plug the new NIC into a PCI slot and secure with the screw from the access cover.
Figure 6-13. Plugging the new NIC into the PCI slot
Note:
Your in-path NIC must be in slot
1
,
2
,
3
, or
4
. If your in-path NIC isn’t in slot
1
,
2
,
3
, or
4,
it isn’t displayed in the
Management Console.
Note:
When adding 10-Gigabit Ethernet cards, populate slots 2, 3, and 5 before the other slots for best performance.
Use slot 1 next, and use slot 4 last. For 1-GbE cards, the slot position for the card doesn’t matter.
Note:
Make sure the NIC is seated properly. If it isn’t seated properly, the NIC doesn’t function.
Note:
It isn’t necessary to plug in the 12-volt connector of the Two-Port SR Multimode Fiber 10-Gigabit Ethernet
PCIe card.
10. Close the top cover of the SteelHead.
11. Connect the power cords.
12. Connect the LAN and WAN cables.
Note:
Straight-through cables connect the LAN ports to the LAN switches; crossover cables connect the WAN ports
to the WAN routers.
13. Power up the SteelHead and check the status lights.
For a detailed figure of the NIC status lights, see
Appendix C, “NIC Status Lights for xx60, xx55, and
14. Connect to the SteelHead CLI.
For detailed information, see the
Riverbed Command-Line Interface Reference Manual
.
15. Enter enable mode. At the system prompt, enter the following command:
amnesiac > enable
amnesiac #
Содержание NIC LR
Страница 8: ...8 Contents ...
Страница 16: ...16 Getting Started Troubleshooting ...
Страница 48: ...48 Installing Network Cards in xx80 Appliances Identifying interface names ...
Страница 106: ...106 Installing NICs in SteelHead xx50 Appliances Installing NICs in 3U xx50 appliances and Interceptor 9350 ...