6.
Apply power to the control box and enter fill mode.
a.
Press and hold Diagnostic/Fill Mode Button on the
inside of the control box until horn chirps. See figure
9.
b.
After horn chirps, press the following buttons in
order to enter fill mode. See figure 10.
1b. LOCK
2b. HORN OVERRIDE #2
3b. LOCK
c.
Controls are now in Fill Mode. Holding the LOCK or
UNLOCK Button will run the pump up or down.
7.
Cycle the DOK-LOK up and down to remove air
from the system. Add remaining hydraulic fluid. Stop
cycling once the support cylinders travel up and
down the full length of slots without hesitation.
8.
Press Diagnostic/Fill Mode Button to exit Fill Mode.
NOTE:
Must wait one minute to exit Fill Mode.
9.
To complete installation test operation. See Owners
Manual.
Pub. No. 1243 — April 2008
11
RITE-HITE
®
STR-4100 DOK-LOK
®
Installation Manual
INSTALLATION CONT.
Diagnostic / Fill Mode
Button
FIGURE 9 - DIAGNOSTIC / FILL MODE BUTTON
NOTE:
You must wait one
minute to exit Service
Mode.
GREEN
RED
LOCK
UNLOCK
OVERRIDE
HORN
3
2
1
Control Box
Press Buttons In The Following
Order To Enter Fill Mode
1. LOCK Button
2. HORN OVERRIDE #2 Button
3. LOCK Button
DO NOT
ENTER
TRAILER
ENTER
TRAILER
FIGURE 10 - ENTER FILL MODE
