Riso MZ1070, Техническое руководство

Страница: 43 / 150

[ 15-9 ] MZ870 / MZ890 / MZ1070 / MZ1090 (Revision 0.9)
TEST MODE
3. System Panel Test Mode
No. Sensor/Switch Detecting Condition
Print drum
changeover
0001 Wake-up Key The key pressed. -
0002 Solenoid Counter Connection Signal The solenoid counter is connected. -
0003 24V A output signal 24V-A ON (there is a 24V output) -
0004 24V B output signal 24V-B ON (there is a 24V output) -
0005 Rear Cover Safety SW Switch ON (main unit rear cover is installed) -
No. Motor/Solenoid Remarks
Print drum
changeover
0062 Wake-up LED The LED illuminates. -
No. Unit Check
Print drum
changeover
0080
Test Print A (Checkered)
A
Creates a master with Test Pattern 1 (Checkered).
0081
Test Print B (Crossed Lines)
A
Creates a master with Test Pattern 2 (Crossed Lines).
0082
Test Print C (Dot 1)
A
Creates a master with Test Pattern 4 (Dot 1).
0083
Test Print D (Dot 2)
A
Creates a master with Test Pattern 5 (Dot 2).
0084
Test Print E (Dot 1 + Crossed Lines)
A
Creates a master with Test Pattern 6 (Dot 1 + Crossed Lines).
0085
Test Print F (Dot 2 + Crossed Lines)
A
Creates a master with Test Pattern 7 (Dot 2 + Crossed Lines).
0086
Test Print G (Dot 3 + Crossed Lines)
A
Creates a master with Test Pattern 8 (Dot 3 + Crossed Lines).
0087
Paper-Feed Test (continuous feeding)
A
Prints continuously.
* The Speed key is enabled.
* If the rear cover safety switch is OFF, the operation begins when the rear cover safety
switch is turned ON within 10 seconds after the START key is turned ON.
0088
Low-Speed Printing Operation
A
Prints continuously at 15 rpm.
0090
Machine Firmware Download
-
Pressing the START Key starts the Firmware download.
0094
Unit Initialization
-
Returns mechanical moving units to their home positions. (scanner, thermal print head,
compression plate, clamp units, vertical print position, printing pressure)
(Note) Meaning of symbols used in the <Print drum changeover> column in the Test Mode chart.
A : <First print drum side> , <second print drum side> , or <both first and second print drums>
can be selected.
B : <First print drum side> or <second print drum side> can be selected.
– : Irrelevant for print drum .