RANGER
- rev.00 - 11
GB
Assembly instructions - RANGER 500
4 - Fit the clamps as in the figure locking them in position with the washer and the M10
hexagonal head screw. Fold them according to the foundation.
5 -Carry out the excavation in the ground with the measurements indicated in the image
alongside and prepare a suitable draining foundation. Insert the foundation case in the
excavation.
Attention: The case must rest on the bottom of the excavation and
must be perfectly vertical - check this by placing a spirit level on the
upper flange.
Attention: Make sure, during the cast, that the fixing plug you find
under the cramp-iron is completely covered with concrete. Using a
spirit level, check if the flange plane is horizontal.
6 - After installing the foundation case, make sure you close the hole with an adegate plug
until the time you install the bollard, in order to avoid accidents to to people or things.
See figures alongside.
Hole 800x800x1000 mm with draining foundation
400
Cement
300
Fine
Sand
300
Gravel
Drainage pipe min. diam. 10mm