Ripmax Sigma EQ ECO II, Руководство по эксплуатации

Страница: 20 / 36

20
LiPo STORAGE
2.0A 1 1 . 1 V ( 3 S )
LiPo DISCHARG
1.0A 1 1 . 1 V ( 3 S )
Li3s 2.0A 12.59V
STO 022:43 00682
Li3s 2.0A 12.59V
STO 022:43 00682
Number
of cells
Number
of cells
Elapsed
time
Elapsed
time
Charge or discharge current
Discharge current
Capacity
changed
Battery
voltage
Battery
voltage
Discharged capacity
Voltage balancing and monitoring in the charge/discharge process
This monitors the voltage of each cell when the battery packs are in the charge/discharge process. If the voltage of any
cell is abnormal, the screen will show an error message and terminate the program. If there is some battery damage or a
disconnection you will be shown an error message, press the button see which cell is damaged.
Storage control of Lithium battery
This function is for charging/discharging batteries which are not used at once. This program is designed for charging or
discharging batteries of a specific original state. They are classified by types: 3.70V LiIo, 3.80V LiPo, 3.85V LiHV and
3.30V LiFe. The program will begin to discharge if the original state of the battery exceeds the voltage level of storage.
At this screen, you can set up the current and voltage of the battery pack. Charging and
discharging will make the batteries come to the voltage level of the ”storage” state.
This screen shows the real-time status charging. Press the button once to stop the charge
process.
Discharging Lithium battery
The value of the discharge current on the left can not exceed 1C, and the value on the right
can not be under the voltage recommended by the manufacturer to avoid deep discharging.
Press the button for more than 3 seconds to start charging.
This shows the real-time status of discharging, you can press the button to stop
discharging.