Rinnai
27
RHFE 952_1252 OIM
HEATER INSTALLATION
Installation of Granular Burner Media (Both Models)
1.
Ensure that all the logs are firmly seated in their correct positions
and check that the ports of both burners are clean and clear of
blockages from debris that may have been deposited during the
log installation.
2.
Carefully place the supplied granular burner media over and
around the front and rear burner ports.
B. Installation of Ceramic River Stones (Both Models)
Replacing Combustion Chamber Glass
1.
Tilt the Combustion Chamber Glass
forward by about 10°
and sit it onto the bottom supports of the Combustion Chamber
frame and rotate back to vertical at the top.
2.
Replace and
HAND TIGHTEN
the four retaining screws
, then
back each of the screws off by a ¼ of a turn to ensure the
combustion chamber glass retaining springs are engaged.
To test this gently pull the top of the glass frame forward and
release, a correctly fitted the glass will spring firmly back into
place and seal the combustion chamber.
It is desirable that the gas jets are diffused by the granular burner media, as this will reduce any
'candling' effect of the flame, as well as enhance the flames look and the realistic log burning
appearance of the heater.
DO NOT place granular material on top of the pilot or force any
granular material into and or completely block any of the burner ports.
Time taken for complete ignition of both front and rear burners MUST NOT exceed 35 seconds. If
complete ignition exceeds 35 seconds reposition granular media as per step 2 above and re-test.
The stone set for the RHFE-952ER consists of 30 stones of various
size, colour, quantity and shape, of these there are 5 stones that
have a central location slot
.
The stone set for the RHFE-1252ER consists of 40 stones of various
size, colour, quantity and shape, of these there are 5 stones that
have a central location slot
.
Note: Same install method used for both models, RHFE-952ER shown.
1.
Place one of the slotted stones
onto each of the five brackets
located on the front burner, ensuring a random orientation of
these stones will achieve the best visual appearance.
2.
Place the remaining stone types evenly over the surface of both
burners in a random manner, ensuring a random orientation of
these stones will again achieve the best visual appearance.
The TOP VIEW image to the right may be used as an
approximate guide to the stone placement.
3.
Carefully place the supplied granular burner media in and around
the stones. For the best flame effect carefully place the granular
burner medium over and around the front and rear burner ports.
It is desirable that the gas jets are diffused by the granular burner media, as this will reduce any
'candling' effect of the flame as well as enhance the flames look.
DO NOT place granular material on top of the pilot or force any granular material into and or
completely block any of the burner ports.
Time taken for complete ignition of both front and rear burners MUST NOT exceed 35 seconds. If
complete ignition exceeds 35 seconds reposition granular media as per step 3 above and re-test.
HINT
1
1
1
HINT
K
J
J
K
J
Содержание RHFE-1252ER
Страница 31: ...Rinnai 31 RHFE 952_1252 OIM NOTES ...
