Rinnai RHFE-1252ER, Руководство по эксплуатации и установке

Страница: 12 / 32

Rinnai 12 RHFE 952_1252 OIM
REMOTE CONTROL OPERATION
REPLACING THE CR2450 BUTTON BATTERIES
When this low power symbol appears the batteries are near to being fully discharged and are
unable to power the remote control properly. Replacement of batteries is now required.
1.Using a suitable lever remove the back cover by carefully prying off the back cover at the 6 pry
points .
2. Remove the two bridge retaining screws, using a small (No.0) Phillips head screw driver or equivalent.
3. Remove the bridge .
4. Remove the old batteries by carefully sliding them out from under the retainers , and into the space that
was created when the bridge was removed in step 3.
5. Insert two new batteries (CR2450), ensuring the positive “
+
” terminals are facing up.
6. Reassemble the bridge in reverse order as per steps 2 & 3 above.
7. Re-attach the rear cover by carefully clipping it back into place.
LOST, MISPLACED OR BROKEN REMOTE CONTROL
In the event of a lost, misplaced or broken remote control the appliance may still be operated in a limited capacity.
By using the manual control panel,
power ON/OFF button , located on the top left hand side of the heater.
The heater will automatically modulate between flame settings to maintain the default set temperature of 22°C.
No control of the flame or heat output is possible via the appliance ON/OFF button.
f
g
g
h
j
i
j
i
f
Note: Remote contol is shown with back cover removed for illustrative purposes
g
h
i j
h
i
2 a
b
a
2
2
2
NOTE