Rinnai Prestige Close Coupled Systems, Руководство по эксплуатации и установке, Страница: 25 / 48

Rinnai Australia - 23 - Solar Close Coupled Operating / Installation Manual Issue 7 - 16/9/10
STANDARD INSTALLATION CONTINUED
STANDARD INSTALLATION CONTINUED
Fastening Cylinder to a Tiled Roof
• Lift the storage cylinder onto the roof and
locate it above the collector bank. The
cylinder’s position should be as central as
possible to the collector bank. The lower
rail must be on a load bearing surface.
• Slide the cylinder support strap into the
slots located in the uppermost cylinder
support bracket (shown in
Figure 21 ) so
that the strap are in line with the rafter or
as close as possible to them.
Figure 21 - Cylinder Support Strap
• Remove tiles one row up from the storage
cylinder. Apply tension to the straps and
attach them to the rafters using a suitable
fastener.
• Replace the tiles
Figure 22 - Cylinder Installation Tiled Roof
Fastening Cylinder to a Metal Roof
• Lift the storage cylinder onto the roof and
locate it above the collector bank. The
cylinder’s position should be as central as
possible to the collector bank. The lower
rail must be on a load bearing surface.
• Slide the cylinder support strap into the
slots located in the uppermost cylinder
support bracket (shown in
Figure 21 ) so
that the strap are in line with a suitable
fastening point.
• Bolt the lower support rail to the roof using
a suitable fastener.
• Apply tension to the cylinder support
straps and attach them to the rafters using
a suitable fastener.
• Seal any holes in roof using a suitable
sealant to ensure roof is water tight.
Figure 23 - Cylinder Installation Metal Roof
FASTEN STRAP
TO RAFTER
TILE
REMOVED
LOWER CYLINDER RAIL
MUST BE ON A LOAD
BEARING SURFACE
BOLT STRAP TO ROOF USING
A SUITABLE FASTENER
BOLT RAIL TO ROOF USING
A SUITABLE FASTENER
LOWER CYLINDER RAIL MUST BE
ON A LOAD BEARING SURFACE LOWER CYLINDER RAIL MUST BE
ON A LOAD BEARING SURFACE
INSTALLATION OF SOLAR COLLECTORS & CYLINDERS