G A S C Y L I N D E R I N S T A L L A T I O N
16
16
CONNECTING TO GAS SOURCE
1.
Open the front doors of cabinet. Pull out the gas
cylinder tray. Place a 9 kg gas cylinder with foot
ring into the hole in the tray. Make sure the gas
cylinder valve is in the
‘OFF’
position.
(Turn clock-
wise to close.)
Align the gas cylinder so the cylinder
valve faces the rear right corner of cabinet. Use
provided wing bolt to secure gas cylinder.
2.
Ensure all burner valves are in the
‘OFF’
position.
3.
Inspect the valve connection opening and regulator
assembly. Look for damage or debris. Remove
any debris. Inspect hose for damage. Never use
damaged components.
DISCONNECTING TO GAS SOURCE
1.
Turn all burners to
‘OFF’
.
2.
Turn gas cylinder valve off fully.
3.
Detach the regulator assembly from gas cylinder
valve.
4.
When connecting the regulator assembly to the gas
cylinder valve, hand tighten nut anti-clockwise to a
full stop.
5.
Open the gas cylinder valve fully. Use a soapy
water solution to check all accessible connections
for leaks before attempting to light your barbecue.
See "Checking for Gas Leaks" on page 5.
If a leak is
found, turn the gas cylinder valve off and do not
use your barbecue until the leak is repaired.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder.
CONNECTING AND DISCONNECTING
TO GAS SOURCE
TEST FOR LEAKS WITH A
SOAP SOLUTION, NEVER WITH AN
OPEN FLAME.
(REFER TO page 5)
!
IF THIS INFORMATION IS NOT
FOLLOWED EXACTLY, A FIRE
CAUSING DEATH OR SERIOUS INJURY
MAY OCCUR!
DO NOT STORE A SPARE GAS CYLINDER
IN THE STORAGE COMPARTMENT OR
NEAR THIS APPLIANCE.
NEVER FILL THE CYLINDER BEYOND
80% FULL.
THIS BARBECUE IS ONLY TO BE USED
OUTDOORS.
!
DISCONNECT OR REMOVE GAS
CYLINDER WHEN MANOEUVRING THE
BARBECUE OVER UNEVEN SURFACES
OR CARRYING UP AND DOWN STAIRS
!
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, make sure all burner controls
are in ‘OFF’ position.
NOTE: The ‘OFF’ position on the control panel is
identified by a black dot. When the word ‘OFF’ printed
on the control knob aligns with the black dot on the
control panel, the burner is in the fully ‘OFF’ position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder.
Familiarise yourself with the general information
and safety guidelines located at the front of this
manual. Check to see that gas cylinder is filled and that
the end of each burner tube is properly located over
each valve orifice. Set burner controls to
‘OFF’
position.
ENSURE BURNER CONTROLS ARE OFF
S233G04332 (x1)