A
S
S
E
M
B
L
Y
13
13
B
Gas valve tip
A
Side burner body
Side burner body
Wind shield
Ignition wire
Side burner hose
Fastening strip
1.
Insert the side burner gas valve assembly through
the side burner gas valve hole on the side burner
shelf. Align the two (2) holes on the side burner
shelf with the threaded holes on the side burner gas
valve bracket.
2.
Tighten securely using two (2) screws and washers
provided.
3.
Push the control knob onto the side burner gas valve
stem, be sure that the
‘OFF’
position faces the burner.
4.
Install the side burner body through the top hole in
side burner shelf and onto the side burner gas
valve. Make sure that opening at end of side burner
connection tube goes over tip of the side burner gas
valve.
Refer to diagram A.
Secure the rear of the
side burner body with supplied cotter pin.
Refer to diagram B.
5.
The gap between the side burner electrode tip
and the side burner port should be approximately
4 - 5 mm. Adjust if necessary.
6.
Place the pot support and wind shield into position
as shown below.
7.
Connect the electric wire terminal from side burner
with the lead connection from barbecue body.
Thread the supplied fastening band through the
hole on the top of the right trolley side panel. Bind
the connected electric wire and side burner hose
together using the fastening band.
INSTALLING SIDE BURNER KIT
Side burner
electrode
Burner port
4-5 mm
Cotter pin
P05501010B
Pot support
Washers S411M04122 x2
Control knob
Gas valve assembly
Screws S132M0482 x2