Rinnai Infinity 14e, Руководство по эксплуатации и установке

Страница: 12 / 52

12
1.3.1 SELECTABLE TEMPERATURES
The appliance is set at the factory to allow the selection of a maximum temperature of 55°C. This limit is generally more
than adequate for most domestic uses, but it is possible to modify it according to your needs. A Rinnai specialized
technician can modify the device electronics by modifying the maximum allowed temperature, bringing it to a higher
value or limiting it further. This change is not permitted to domestic users. Rinnai recommends setting the appliance
to the minimum temperature best suited to the intended use to reduce gas consumption and to increase the life of the
appliance.
The control panel supplied with the appliance is factory blocked: it is possible to increase the temperature up to a
limit of 50°C. Higher temperatures can be obtained only after having unlocked the control panel: correctly performed
the release procedure, it will immediately be possible to increase the delivered temperature and reach the maximum
value set on the appliance. The unlocking (and locking) procedure is described in the section dedicated to installation
instructions, and it is allowed to specialized personnel only.
The temperatures that can be selected using the control panels are as follows:
Selectable
temperatures (°C)
Master 37, 38, 39, 40, 41, 42, 43, 44, 45, 46, 48, 50, 55, 60
1
, 65
1
Sub 37, 38, 39, 40, 41, 42, 43, 44, 45, 46, 48, 50
1 selectable temperatures after changing the PCB parameters.
The temperatures below are intended as examples: you can set them according to your lifestyle. Remember that low
usage temperatures help to reduce consumption.
Suggested
temperatures
kitchen 50°C ~ 55°C Bathroom 37°C ~ 43°C
Temperatures below 37°C can be obtained by mixing with cold water.
1.3.2 OPERATION WITH THE STANDARD CONTROL PANEL
The control panel supplied with the outdoor models (Standard remote control - MC-601) and the internal models
control panel (installed on the front casing) have similar appearance and functions:
Turning on
If the control panel is switched off, press the On/Off button: the led on
the button lights up (models for outdoor) and the display shows the
temperature, indicating that the appliance is ready for use.
Adjusting temperature
Select the desired temperature using the hot water temp or buttons
until the required temperature is displayed on the digital monitor.
To operate the hot water unit, open any hot water tap: the appliance will
control the temperature and turn on the burner only if it is necessary to heat
it. When the burner is on, the ‘In Use’ indicator will light up on the controls
connected to the appliance.
Once the hot water is running, if the set temperature is either too hot
or too cold press the hot water temp or buttons until the desired
temperature is reached.
Indicates the temperature selected.
In event of a fault it flashes an error code.
DIGITAL DISPLAY
Used to select the temperature of hot water.
TEMPERATURE CONTROL BUTTONS
Indicates that the water heater is on.
ON/OFF LED (only on remote controller)
Used to switch on/off the water heater.
ON/OFF BUTTON
Indicates if this water controller is in control of the water
delivery temperature.
PRIORITY LED
Used to transfer the control on the water heater between
controllers.
PRIORITY BUTTON
Indicates that the water heater is delivering hot water.
'IN USE' LED
HOT HOT
COLD COLD
OPEN OPEN